Tractor Talk Discussion Board |
Re: IH 3400A Backhoe Boom Hydraulic Problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by massey333 on December 28, 2006 at 13:21:25 from (209.143.57.22):
In Reply to: Re: IH 3400A Backhoe Boom Hydraulic Problem posted by epkasl on December 27, 2006 at 20:01:46:
Hope this means something but probaly not.Ford and Kelly and one or maybe two others used a valve body in the mid 80s to early 90s that had a bad problem with SOMETHING(dirt, casting sand or????)getting into a valve and making it Bypass.They were a Cartrage type unit that could be washed out and put back in and would work 95% of the time.If you have a Ford Ind.Dealer close you might check with him for that valve.Hope this might help but good luck anyway.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|