|
Tractor Talk Discussion Board |
Just what I needed....need advice.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill46 on December 27, 2006 at 05:56:11 from (63.65.68.246):
Need a little advice here...
Went home to the old farm last weekend. Went down to Dad's shop just to look around and make sure everything was ok.
When I walked up to the side door I saw liguid ozing across the concrete.
Seems someone had broken a window out of the overhead door and proceeded to shoot a bunck of plastic jugs where dad stored hydraulic and motor oil with a pellet gun.
Well, I went to tractor supply and got enough oil dry to clean up the mess, but was wondering about the remainder of the oil and hydraulic fluid.
Some of the jugs are still over half full. Can I put the remaining oil in containers and use it? Or should I just get rid of the whole mess?
There is a lot of oil in those containers. Dad bought everything by the case so I really hate to get rid of it all.
Any advice is always welcome.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
