|
Tractor Talk Discussion Board |
Re: It's Going In There No Matter What
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobInMN on December 23, 2006 at 07:41:49 from (206.145.27.86):
In Reply to: It's Going In There No Matter What posted by Allan In NE on December 23, 2006 at 04:52:32:
Here is a stupid idea. Set scaffolding up on each side of the tractor. Bridge over the top with some 2X4's. Cover the whole thing with reinforced poly (you can buy windclips to install it). Set your torpedo heater inside to heat it. The masons work year round up here in Minnesota doing this. They keep it 65-70 degrees most of the time. Looks like you would have a nice concrete slab to work on so the ground won't turn to mush. When anchored properly these temporary structures will really withstand strong winds.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|