|
Tractor Talk Discussion Board |
Moving snow with a blade
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by sodly on December 21, 2006 at 10:08:22 from (24.106.14.170):
I posted this in an earlier thread but didn't get much response so I thought I'd make a new topic. I've been curious about moving snow with a 3 point blade. In the past I've used 2WD utility tractors and a 6' or 8' boxed scraper (boxed blade) without chains to move snow, but the box quickly fills up and starts piling under the wheels of the tractor, so it's not ideal for large areas or long runs. On the plus side, it's easy to push AND pull snow with a boxed scraper without adjusting anything (since they're designed to push and pull dirt). A lot of the problem is you can't angle a boxed scraper. How well does it work to turn a 3 pt. blade around backwards and push snow with the blade angled? Seems like this would work well but having never tried it, I'm not sure. Can anyone tell me if there's much difference between pushing and pulling snow with a 3 pt. blade? Seems like your driving wheels would more likely be on cleared pavement if you pushed. Also, do they make hydraulic angling blades that will turn 180 degrees under hydraulic power? I don't imagine they do. Finally, how do you size a blade to a tractor? I presume you ideally want one that, when angled, is still as wide as your wheel tracks. Or are they simply sized by the HP rating of the tractor? For instance, how big/small a blade would be ideally suited to a 3020? 6 foot? 7 foot? 8 foot? Sorry for all the novice questions.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
