Tractor Talk Discussion Board |
Re: Oliver 77 engine miss!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by edchainasaw on December 17, 2006 at 17:42:34 from (205.188.117.14):
In Reply to: Oliver 77 engine miss!! posted by wagsw900 on December 17, 2006 at 14:50:52:
the 51 77 we baught this sept. is doing the same thing. Everything he said held for ours. enough Power, not bad miss, had new plugs, wires cap and rotor.. cap was put on wrong we corrected that and didnt change anything. we found the miss was in #5. we then did a compression check... ya it was not good. we pulled the Valve cover and the valves were working so now we will pull the head... well not just yet we will do that sometime "later" LOL.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|