Tractor Talk Discussion Board |
Re: 160* Thermostat, why?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Aaron Ford on December 14, 2006 at 08:43:27 from (72.84.41.177):
In Reply to: Re: 160* Thermostat, why? posted by Bob on December 13, 2006 at 19:50:37:
Thanks guys. The system is indeed a 7lb system. Detonation was certainly a problem in this engine's past. It destroyed the sleeves, piston tops and broke all the top rings. I have seen engines run without a thermostat. One overheated til one was installed? One was sludged up so bad it took three men with pry bars to get the intake manifold off. The owner was using Pennzoil, STP, and making only short trips. Not sure what the real problem was but that engine was completely full. The rest had no problems whatsoever. My first car ran better with a 195* than a 180*. Smoother, alot more "pull". I will monitor the temps on this tractor closely. I have a lot invested and REALLY don't want to make a mistake... I would like to run a hotter thermostat, but likely will leave everything as it is due to what I have changed already (7.1:1 to 9.1:1). Let's get this sorted out first.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|