Tractor Talk Discussion Board |
Re: Att'n Allan in NE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Johnnie T on December 11, 2006 at 17:40:02 from (65.54.154.112):
In Reply to: Att'n Allan in NE posted by Johnnie T on December 11, 2006 at 12:17:31:
Bob dist. shaft turns, the magnet wheel is what I think is the black plastic ring with a green tape at the bottom & it is all the way down & appears to be lined up w/ the ignitor, now about the air gap, the ignitor is fixed to the plate with small bolts hold it in place & tight to dist body there is no way to adjust the air gap that I can see there is no gr.jumper wire just a red wire to + post & black to - post of coil distributor is tight & was installed new 2 yrs ago. I am thinking about installing a new gr. from battery to starter mounts and see if that helps the problem, but at this time I don't think I have agr problem Thanks for all of the help.
Replies:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|