Re: O/T 2000 Kenworth clutch adjustment

Posted by William Pearson on December 09, 2006 at 19:00:48 from (63.27.58.140):

In Reply to: O/T 2000 Kenworth clutch adjustment posted by MeAnthony on December 09, 2006 at 18:49:55:

Anthony,
There should be 1/2 inch between the clutch brake and throw out bearing on the pull type clutch and 1/8 of an inch clearence between the fork and throw out bearing (this is the "toe play"), if the clutch is a Spicer then hold the clutch pedal down to the floor while another person adjusts the adjusting bolt on the clutch plate (you have to push in on the bolt head to turn it). When your done adjusting make sure the bolt heads pops out and locks into place. If the truck has a Solo self adjusting clutch then tighten the clutch linkage so there is no "toe play" then step down on the clutch pedal times till the clutch self adjusts and gives the proper clearence.
Bill in Richmond, Va.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]