|
Tractor Talk Discussion Board |
Re: Propane guy aint making nuttin from me
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Oldmax on December 08, 2006 at 06:05:01 from (24.154.145.248):
In Reply to: Propane guy aint making nuttin from me posted by Dave from MN on December 07, 2006 at 18:08:56:
I use a Englander free standing stove with a Chramic combuster is good for 2400 SQ FT house , But wood has to be dry I cut one year for next . I have enough cut and stacked for 1 1/2 winters. This stove is about 85% efficent . is ten years old you can now buy reg wood bunners that are that efficent .it uses about half the wood as the stove it replaced .I use Natural Gas "Package unit with A/C" for back up unit . Also have 5500 Watt electric start generator for backup power, by using wood for primary heat power unit is big enough to use during power is off . like last week was off 23 hours due to wind storm .
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|