Tractor Talk Discussion Board |
Re: Farmall super m m cylinder head the same?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by no tools on December 07, 2006 at 14:24:51 from (71.79.44.154):
In Reply to: Farmall super m m cylinder head the same? posted by 24farmallman on December 07, 2006 at 09:21:01:
24farmallman as far as i can remember all this heads will interchange (6336casting n)(8777)(8574)(8060) The 6336 an 8777 is distillate or kerosene. Lower compression. The 400 and 450 well interchange the only one we ever had a problem with the piston was the LP off 450? i don't remember if it was the 362 433 r1 or r11 or the 364586 r1 or r11. these two head had a close combustion chamber. Good luck merry christmas. Bill.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|