Re: TO 30 FERGUSON ENGINE OVERHAUL

Posted by Jerry/MT on December 02, 2006 at 18:55:55 from (206.183.116.129):

In Reply to: TO 30 FERGUSON ENGINE OVERHAUL posted by Dave Peter on December 02, 2006 at 08:26:57:

There is a thrust plate, two thrust washers(inner and outer) and then some shims that fit between the two thrust washers that set the allowable endplay(0.003"-0.007")between the thrust face on the crankshaft and the fiber washer. There is also a pin to locate the whole shebang.They all go behind the gear.You should be asking this question in the Ferguson Forum. There is a whole lot of Ferguson experience there.
If you don't have a Ferguson Shop Manual, you ought to to do this job.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]