|
Tractor Talk Discussion Board |
Re: Anybody Still Doing Fall Tillage?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul in Mich. on November 30, 2006 at 05:45:01 from (66.188.27.182):
In Reply to: Anybody Still Doing Fall Tillage? posted by davpal on November 29, 2006 at 21:05:51:
Davpal, Here in Freeland Michigan, we have mud, muck and mire to spare. We"re also mostly no-till, but have cut up the fields so badly that it will take a lot of evening out. We also have nearly 1.200 acres of soys standing with snow comming. The corn is out,but it has been a challenging fall to say the least. We usually disk the rough spots, which this year means nearly all the field, but will wait until spring. I have seen guys chisel plowing and moldboard plowing standing water. Where in mid Mich are you?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|