|
Tractor Talk Discussion Board |
Re: OT Computer Reprogramers
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Stumpalump on November 25, 2006 at 11:09:33 from (71.56.206.103):
In Reply to: OT Computer Reprogramers posted by Mike in Ind. on November 25, 2006 at 08:51:48:
Most of the gains come from advancing the timing and richening up the injectors. You can do the same thing yourself for about a buck. Find the air inlet temperature sensor and add resistance to trick the computer into thinking it is 25 degrees colder outside. The computer will automajicaly richen your fuel and advance your timing and you get more power. Not sure exacally how the chevy is set up but they all work the same way. On the last one I did (2005 Ford Escape) my company car I took the sensor off and read the resistance. I put it in the refrigerator and read the resistance again. I installed a radio shack potetiometer in series and set it for the total resistance I got when it was in the fridge. It wakes the engine up and gives it crisp throttle response. The programers change shift points, tourqe converter lock-up and rev limits but cost you. A 160 degree thermostat works in the same way on the computer so if you do both you will see the same gains as the chip reprogramer.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|