|
Tractor Talk Discussion Board |
Re: One Wire Alternators.....
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on November 24, 2006 at 07:02:49 from (69.67.231.83):
In Reply to: One Wire Alternators..... posted by davpal on November 23, 2006 at 22:11:26:
You can take any Delco 10SI or 12SI, and with ten minutes work install a $12 self-exciting regulator. When I used to use the Delcos, I'd pick them up for $15 apiece and convert them for another $12. I stopped using Delcos, however, since the Hitachi alternators are better built and more compact. On many tractor conversions, a smaller more-compact alternator is sometimes needed. Also, the Hitachis are seal and have full ball-bearing support on both ends - the Delco 10SIs do not. When Deere Co. started using Delco 10SIs in place of the more expensive sealed units, e.g. Motorolas, there were many early failures - most assoiciated with the Delco's lack of sealing against dust. Again, with part-time use tractors that's not much of an issue. And besides, you can buy buckets full of Delcos for $10 - $15 apiece at many junkyards. Many of the Delcos will self-excite without altering - i.e. one-wire hookup - but it's not practical since they usually have to rev up to 3000 RPM to do it. When you buy a pre-converted, over-the-counter one-wire Delco alternator, a 14.75 volt DC self-energizing regulator seems to be the most common choice. Depending on the pulley size used, a tractor often has to be revved up to over 1500 RPM to make it cut in. There are also many other variations of those self-exciting regulators - some cut in at a lower DC voltage, and some sense AC voltage instead. One reason that one-wire hookups are not desired in automtove use - is they lack the ability to sense the small variation of voltage - when measured at the battery and compared to a separate reading at the alternator output. A one-wire hookup nullifies that ability - but for tractor use, it's not very important.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Lifetime of David Brown Tractors - by Samuel Kennedy. I was born in 1950 and reared on my family�s 100 acre farm. It was a fairly typical Northern Ireland farm where the main enterprise was dairying but some pigs, poultry and sheep were also kept. Potatoes were grown for sale and oats were grown to be used for cattle and horse feeding. Up to about 1958 the dairy cows were fed hay with some turnips and after that grass silage was the main winter feed. That same year was the last in which flax was grown on the farm. Flax provided the fibre which w
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|