|
Tractor Talk Discussion Board |
Piston Dome, Compression Ratio Revisited w/pics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Aaron Ford on November 20, 2006 at 19:14:42 from (72.84.34.93):
Heres the pics.
And here's the details of my engine within a quote taken from an earlier post...
"Not really all that well.
The reason for the measurement is that the engine was damaged by the previous owner by detonation, preignition and the like. It broke ring lands, broke the top rings on all cylinders, and actually dented the liner on number 3. Number 2 piston was recently changed. I thought a valve had come apart in the past, but my machine shop seemed to think it was preignition. So with the history of the engine known, it caused great concern when the replacement pistons had a considerable dome. I needed to know if my new setup was going to require 93 octane or would be able to live on 87. The last thing I want to do is purchase a second $869 dollar kit... Here's what I have. 3 37/64 bore, 4 3/4 in stroke, .050 in head gasket with a 3 3/4 in cylinder holes, 110 cc combustion chamber. I measured a 22cc dome at zero deck. It is a 4 cyl engine. I came up with a 9.0649:1 or rounded to 9.1:1. Original engine had flat tops at zero deck and approx 120cc combustion chamber. The engine should measure 176 cu inches, but tht's not what I get when I cipher it out. Whadya'll get?" Thanks Aaron
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
