Re: PM'ing a furnace in my shop

Posted by Scot r Maxwell on November 20, 2006 at 14:13:14 from (63.224.181.102):

In Reply to: PM'ing a furnace in my shop posted by David McDan on November 20, 2006 at 09:37:20:

Make sure power is off first ! Be safe ! If you're not carefull you can lose your eyebrows !If you can reach your burners, clean them with a wire brush and blow them out with an air compressor they will burn orange for quite a bit while burning dirt and dust when you first fire up the furnace. Watch the burners, blue with a little yellow orange candle shape flame is best, if it's more whitish yellow, burners need adjusted. watch burners when blower engages, if burners get eradic when blower engages, large cracks could be the culprit... when someone finds a crack it needs to be substancial to cause problems, however, cracks don't get better.... if the cavity around the burners (heat exchanger)is full of suet clean them well !! blow them out good! always oil the blower. tap the pilot assembly while pilot is lit and blow out with air compressor and relight pilot, unless it's electronic spark or hot surface ignition. good luck.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]