|
Tractor Talk Discussion Board |
Re: wood splitter pictures and comments
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom R Ne on November 18, 2006 at 19:44:10 from (139.55.140.204):
In Reply to: wood splitter pictures and comments posted by phil lowe on November 18, 2006 at 18:39:10:
Well of course the first thing you would need to do is to put a relief valve on that system. The second thing is to take a stop watch and get some accurate extend time readings on the stroke time. A 6 in bore cylinder with a 30 � stroke would take 3.67 gallon of oil to fully extend it. If you are extending in 10 seconds then the pump would be delivering 36.7 GPM. If you are extending in 15 seconds then the pump delivery is 14.68 GPM That is a very big difference so you need to narrow down the actual time. The HP you are going to need is roughly .0007 x PSIG x GPM With 1500 PSI system pressure and 36.7 GPM you are going to need 38.535 HP
With 1500 PSI system pressure and 14.68 GPM you are going to need 15.4 HP, How many gallon did you say your tank holds? With no relief valve I can sure believe you are stalling out you tractor, and a bigger HP unit will build pressure until something breaks.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
