|
Tractor Talk Discussion Board |
Long 610--Oil Piling Up?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RobertM/Oregon on November 18, 2006 at 16:37:08 from (66.82.9.57):
I"m not a diesel mechanic so bear with me here please. I"ve searched the archives and can"t find anything similar. I"ve got this odd stuff going on with oil out the breather. I can start the tractor and it has some blow by, but runs strong anyhow. After about two or three minutes, the breather seems to fill with oil and start to leak out the dump tube. Can be revved or idling--doesn"t seem to matter. Turn it off, give it a minute or so, and it will start and run a while and then the breather can fills and it starts to dump oil again. The top of the tube inside the breather can is higher than the top of the oil filter on this rig. Seems to be some pressure in the valve covers, but taking the caps off and releasing that doesn"t have any effect. Thought it might just be overfilled, so I changed the oil and filter and it was way overfilled. Added the the right amount according to the book (7.4 qts.), but it still does it, but no oil registers on the dipstick. I can take off the valve cover filler caps, and it"s not full up there--splashes a lot is all. It"s like the middle of the engine, just below head level, is filling up and putting the oil out into the breather hole on the block. I think the thing would pump oil through the breather till it ran dry. What drains the area around the cam? Is it possible there are plugged return holes below the head from the cam area to the pan? I"ve go the service manual but can"t tell for sure just what is what. Thanks much, Robert
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Trailerin a Tractor, Chains or Straps? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I bought a trailer and plan to take my CASE VAS to some shows. I don't yet have anything to secure it to the trailer. So which is better to buy and use; the ratchet-type straps or binders and binder chains?
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|