|
Tractor Talk Discussion Board |
Re: Makin' Hay
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MF294-4 on November 18, 2006 at 15:15:20 from (74.34.53.56):
In Reply to: Makin' Hay posted by Allan In NE on November 18, 2006 at 03:42:46:
Never seen any hay stacked. Started helping with hay in the early 60's. Had a IH wire tie baler with a engine on it. Pulled it with a IH B most of the time, though it was a load for it.Finally got a New Holland hayliner 78 I think, that was a baler. Put hay up in a big barn with hay hooks and a track down the center. Used a B to pull it up too. We used B's to mow,rake,bale and haul. Took a large crew. My brother just buys all his hay now. Can't find the help or to much work.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|