Tractor Talk Discussion Board |
Re: Adding a PTO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MSM on November 18, 2006 at 07:57:04 from (62.12.37.3):
In Reply to: Adding a PTO posted by T on November 18, 2006 at 06:00:40:
Unless it is a very slight load(5-10 hp(,a hydraulic motor will probably not do the job you want.To have any power, the motor will have to be fairly large,then add a gearbox to drive the shaft,plus it will take alot of oil flow to run it,and require a motor spool in your valve bank.While it is running,I doubt if you will have enough pump flow in reserve to even operate a cylinder on another remote without affecting the power and speed of the pto. Abilene Machine or Big Tractor Parts have salvaged a number of Steigers and will probably have a take out PTO assembly for your tractor but it will be the large diameter 1000 rpm stub.
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|