Tractor Talk Discussion Board |
Re: Doesn't make sense to me
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on November 18, 2006 at 06:09:41 from (69.67.230.86):
In Reply to: Re: Doesn't make sense to me posted by doogdoog on November 18, 2006 at 00:35:51:
I don't consider it feasible myself. In regard to running an underground service 400', all that was needed was spending a few more bucks for the correct size cable and using 220 VAC. I cannot imagine why a qualified electrician would recomment #2 aluminum for a 400' 100 amp sercive. In regard to 48 volt systems, I've had that issue here. I've got a 48 volt, DC, 5500 watt solar array that as originally going to be 400 a foot run to my house. Running it all in one cable was not feasible. One option was a bunch of separate DC strings - but since 48 VDC is the highest my inverter can use, it would not work well running that long of a distance. Each solar panel is 175 watts and 24 volts, so I could of run multiple 48 VDC, 14 amp strings and MANY wires. That's why many solar arrays now use inverters that can run at 600 VDC instead of 48 VDC. Problem is - those systems are for grid-tie systems that will not work without grid-power. My system can work both ways. I also could of installed the battery bank outside with the solar panels and eliminate the DC run to the house. With the inverter plus booster outputting 480 VAC at 110 amps, the run would work with 2/0 aluminum. I decided the heck with it, and spent the past summer escavating the side of a mountain - in order to create a site for the solar array closer to the house. It's now at 140' instead of 400'. It still needs 4/0 aluminum at 120 VAC, or 1/0 at 240 VAC.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|