Tractor Talk Discussion Board |
Re: Hey You Ampacity Guys!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 135 fan on November 16, 2006 at 22:32:07 from (68.149.51.133):
In Reply to: Re: Hey You Ampacity Guys! posted by Brett in KS on November 16, 2006 at 19:40:13:
If it was a 60 amp instead of a 50 would work. I had an electrician that did all the electrical for a large complex for university students hook up a welder for me. He put the plug in right on the power pole and wired it to the main 100 amp breaker. He told me that if there ever was a problem the main circuit breaker would trip. I should have been clearer, I meant a 60 amp would work. If the welder is drawing more than rated amps it might already be wrecked. Sorry for the confusion. Dave
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|