|
Tractor Talk Discussion Board |
Re: Moth balling my Ford 641.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim, Ohio on November 10, 2006 at 02:11:06 from (67.140.111.3):
In Reply to: Moth balling my Ford 641. posted by coflyboy on November 09, 2006 at 18:26:33:
My manual for my boat engine has me disconnecting fuel line. Then fill sediment/fuel filter bowl with stabil. Start engine, let it run until stabilizer is through fuel system. Shut it down. Remove plugs, then spray cylinder heads with fogging oil. Work flywheel back and forth to distribute oil well. Replace plugs. Also, change oils, including any gear oils to assure no water is left in any areas that might freeze and cause cracked housings. I assume all of this would apply to tractors. I will follow these steps on mine, if they are to sit unused for over two months. Of course, none of this is crucial if you have heated storage. Best regards, Tim, Ohio
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|