Tractor Talk Discussion Board |
Re: O/T Movin' rocks
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by coflyboy on November 05, 2006 at 07:22:56 from (71.34.139.138):
In Reply to: Re: O/T Movin' rocks posted by old on November 04, 2006 at 18:10:56:
Thanks to all who are trying to help. I'm building terraces, 30 to 60 feet long, on the side of a mountain. It's quite steep. Using the tractor I can load materials on the terraces from the bottom or the top. The terraces are three to seven feet wide with trees etc. in the way, so there is no room to manuever. As I said I'm using a 2-wheel dolly but that is so frustrating I usually do something stupid and am laid up for a couple of days. By the 'tone' of this forum I suspected there would be a few BTDTs out there. Again thanks.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|