|
Tractor Talk Discussion Board |
Re: This may be the first time this has been asked
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by low budget on November 05, 2006 at 04:04:34 from (170.215.211.81):
In Reply to: Re: This may be the first time this has been asked posted by jdemaris on November 04, 2006 at 18:57:38:
Yep. Three bolts, you need to turn the engine over to get all three. Just loosen them a little. At one place there will be a timing mark on one plate to use as a reference against the other plate. Remember to retighten all the three bolts after each adjustment , (before each trial run).Dont horse on them they're small. But remember a diesel wont burn more fuel than it needs to do the job, unless your puffing lots of black smoke every time the engine accelerates you wont see much difference. Check or replace your filters first (air and fuel) like the others said. Does that sound about right to you?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|