|
Tractor Talk Discussion Board |
Re: Kinda Bummed Out :(
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 135 Fan on November 03, 2006 at 11:11:06 from (68.149.51.133):
In Reply to: Re: Kinda Bummed Out :( posted by Allan In NE on November 03, 2006 at 08:05:37:
I have an industrial cab I adapted to my tractor. The door is in two and both are on pins so they can be taken off if you don't want them on. Could you put the bottom door on hinge pins and just lift it off when you get in and then put it back on? In the summer you could just leave it off if and it would be easier to get in. Just a thought. Dave
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
