|
Tractor Talk Discussion Board |
Re: removing distributor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by B-maniac on October 27, 2006 at 19:11:13 from (207.241.132.151):
In Reply to: Re: removing distributor posted by Janicholson on October 27, 2006 at 10:21:33:
Bottom line to what they are saying is this. The exact direction the rotor is pointing AND the exact position where the dist housing base bolts on MUST be marked AND recorded so it goes back in EXACTLY where it came out from. Also chalk mark the fan belt/pully so you can make sure the engine hasn't turned slightly before you put it back in. Just HOW you do all this is up to you,but this is what you need to do.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
