|
Tractor Talk Discussion Board |
Re: How much weight will it hold
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on October 23, 2006 at 18:37:17 from (4.245.14.117):
In Reply to: Re: How much weight will it hold posted by Janicholson on October 23, 2006 at 18:26:18:
Jim, this stuff it so wet right now you can't make it burn with out diesel fuel etc. put on it first. Plus in my area I have no codes to worry about at this time. My shop or at least in this area is all metal. The main frame is old mobile home frame 10-12 inch I-beams and the roof is heavy sheet metal. I figured in welding the rod to the frame and then sort of laceing it in and out of its self. I'm just wanting to know if done this way if it would hold say 500LBS or so. This foam is large, 12-14 inches thick and some si long enough that the grid would not be needed but I want to make sure if it broke it wouldn't hall on my head. LOL
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
