|
Tractor Talk Discussion Board |
fencer ground
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmer in the Dells (WI) on October 23, 2006 at 05:39:26 from (66.187.42.49):
I have two electric fences going up that will share one line between them dividing two pastures. That line will have double wires because both pastures will be charged by separate controllers. It is basically shaped like a figure eight. That particular double line is where I am putting the ground system for one of the pastures. I am using three ground rods ten feet apart to ground it due to being more on the sandy side in the area. My question is has anyone used the same grounding system to complete the circuits using multiple controllers? In my mind they should be separate because the charge is directed to and through another part of the pasture. Has anyone done this? Had any success or problems?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
