Tractor Talk Discussion Board |
Re: Corn and Pellet Stoves
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by morningwood on October 21, 2006 at 07:18:03 from (66.82.9.84):
In Reply to: Corn and Pellet Stoves posted by Wrenchbender on October 20, 2006 at 19:37:59:
I purchased a wood burning stove myself a few years ago.I also have easy access to good hardwood to run it on. I talked to a few people that have pellet stoves and they told me that a major issue with them is that during the middle of the winter they cannot find pellets. I was at TSC last year in January and there were people lined up in the store_waiting_to buy pellets that were being shipped to the store that day. I asked the guy there and he said they running out on a daily basis. Last year was not very cold also. My advice is that if you can afford it, buy all your pellets in the summer so you do not have to wait in line. If you are in farm country I am sure that you could find a farmer that would be more than willing to sell you some of his feed corn. I am not sure how clean or what moisture content it has too be. You also have to worry about mice when storing your corn. If I did not have access to wood I personally would have gotten a anthracite coal stove. On a per lb per BTU basis you get the most heat out of lb of coal and you do not have to worry about the mice or a store having it in stock. In the fall time you should be able to get x amount of tons worth of coal dropped off to burn then you would just need to feed the hopper as you would a pellet or corn stove. Harmon and Hitzer ( non - electric ) make some really nice pea / nugget style coal stoves. Thanks, Scott
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|