|
Tractor Talk Discussion Board |
Re: Perkins question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Joe-Bob/IN on October 21, 2006 at 05:52:05 from (216.241.135.230):
In Reply to: Perkins question posted by mad scientist:P on October 20, 2006 at 07:35:38:
If I remember correctly there are only 3 commercial duty engine bolt patterns. And there are adapters to match all to one and another. Most likely a large truck shop could get you one or a good weld shop can easily make one. Perkins are a rather rare engine 'round here, personally if I were to take on this kinda project I'd stick in a Cat... at least then you'd have some real bite.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Farming Never Left My Blood - by Stan Gordon. I was born in 1947 youngest of ten of a working farm. Our farm was located in Saskatchewan near Saskatoon. We had a mixed farm consisting of grain and dairy all done with old machinery and by hand. My dad had a tractor, a Farmall A which was used mostly to run the thrashing machine, a seed drill and for plowing. I remember locals used to help each other and threshing was done from daylight to after dark, one farm to another until all farms were done.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
