|
Tractor Talk Discussion Board |
Re: Endgate Seeders
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John S-B on October 18, 2006 at 09:34:56 from (69.218.235.183):
In Reply to: Endgate Seeders posted by in-too-deep on October 18, 2006 at 08:53:50:
Deep, when I used to plow snow we just used a good 50-80# walk behind spreader. We used the ones with plastic wheels so we could put hex head self tapping screws in for traction on ice. Around 60-80 bucks for one of these. They where easy to load, just pull a bag of salt to the tailgate and cut it open and the salt just empties right into the spreader. pretty quick unless you have to salt a huge lot or a long road. VERY cost effective, much less than a commercial spreader and you don't have to climb up in the truck to reload the hopper. If you rinse them off after each use they'll last 2-3 years.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|