Welder charging system.

Posted by doogdoog on October 16, 2006 at 23:58:52 from (75.80.223.143):

Aloha,
I have a Lincoln welder and have a question on the charging system. The regulator has 1 terminal in the back that goes to the A terminal on the motor/generator (used to start the engine and chagres the batt). There are 3 terminals on the bottom of the regulator marked L (tech said that is used for the idiot light if wanted), F goes to F on the motor/generator, and B goes to the battery. Ok now the question, if I wanted to polarize the generator, how would this be done? I saw one article that says to momentarily place a short jumper wire from the Batt terminal to the Gen terminal of the regulator. What would be the gen terminal?? Would that be the terminal in the back of the regulator that goes to A on the motor/generator?? TIA

Mahalo,
doogdoog

Replies:

• Re: Welder charging system. John T 07:32:23 10/17/06 (1)
  • Re: Welder charging system. doogdoog 14:39:37 10/17/06 (0)
• Re: Welder charging system. here ya go 07:02:07 10/17/06 (2)
  • Re: Welder charging system. John T 07:35:25 10/17/06 (1)
    • Re: Welder charging system. here ya go 08:20:12 10/17/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]