|
Tractor Talk Discussion Board |
Shop Security
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bryan in Iowa on October 16, 2006 at 06:00:45 from (64.12.116.74):
Two part question here. I was wondering what you folks use to secure your buildings ? Making sure hinge pins are welded , dead bolts, plate over locks to prevent prying jamb open , bar across door etc. shop the hit here last week , they cleaned out couple tool boxes and shop tools . Also , alarms, alarm companies, cameras ,internet camera's ??
Trying to make sure I have everything covered.I know if bad guys want in they will find a way , but anything to slow them down . I have even seen them drive a car through overhead sho door to get in a place . I use to have a big ol dog ,,but he got lil too mean and too much of a liability .
Thanks
Replies:
Home
| Forums
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
