Tractor Talk Discussion Board |
Re: Propane Tractor Fueling
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glen in TX on October 14, 2006 at 18:18:54 from (208.246.9.32):
In Reply to: Re: Propane Tractor Fueling posted by Ol Chief on October 14, 2006 at 16:58:12:
That would work to fill one all right but be a bit slower than equalizing or running off some vapor. You can reduce the pressure of a tractor tank to fill it faster by running it on vapor 30 minutes to a hour before shutting down to fill also. A lot of it depends on where you live and what mix is common in your area now days compared to what we had years ago too with higher mixes of butane. Butane and propane are LPG liquified petroleum gases. Both are a gas at ordinary temperatures but are changed to liquids by compressing them in a tank. Butane boils at + 31 degrees F. and propane at - 44 deg. F. Mixtures of the two gases have boiling points between these two values because of different mixes that can vary from area to area. To keep the fuel liquid it must be kept under pressure at all times. This pressure can range from a few pounds in cold weather to extremely high pressures in hot weather. Both butane and propane are heavier than air and will settle in low quiet spots along ground or floor so it's not the same as all gases and being aware of that requires different handling to be safe with it. You want to be sure if butane or propane escapes everything is vented and none left in low lying areas if a spark were to occur. Natural gas is different and will rise in the atmosphere being lighter than air. Propane is as safe a fuel to use as any other once you understand it and handle it carefully.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|