Re: How to clean out cylinders

Posted by Sloroll on October 14, 2006 at 12:05:18 from (69.66.79.96):

In Reply to: How to clean out cylinders posted by old on October 14, 2006 at 11:26:01:

Well, Of course the best way would be to pull the head but since you are really wanting to start it, there are sparkplug adapters for worn out tractors that blow a lot of oil and debris. The adapter screws into the block and the plug into it. there is a smaller hole in the adapter to keep foreign matter out.
Does the old heffer have a belt pully? I havn't been around D-17s much to remember. If so you could belt it to another tractor too.
If there wasn't oil alredy in the cylinder you could open the valves and use a shop vac in the plug hole to remove some dry matter. I've done that too.

Replies:

• Re: How to clean out cylinders old 12:37:42 10/14/06 (1)
  • Re: How to clean out cylinders Sloroll 13:29:22 10/14/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]