Tractor Talk Discussion Board |
Re: HELP with MOCO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jonfarmer on October 11, 2006 at 16:49:22 from (4.156.249.238):
In Reply to: HELP with MOCO posted by Devin Sparks on October 11, 2006 at 14:47:55:
I had the same problems with my Hesston 1070 MoCo, the problem was I had a broken spring on one side, it's one of the big ones the holds the head up located in the back of the mower, and is adjustible so it can be properly adjusted to float on the field. After replacing the broken spring, I adjusted both of them so that the head was level and just off the ground in the fully down position, and this fixed my problem. When the sickle is touching the ground, it does plug and doesn't cut good, so thats why it is important to adjust it just off the ground. With these springs you can adjust the height of the cut to where you want it. Hope this helps,
Replies:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|