Tractor Talk Discussion Board |
Re: Working small plots
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Errin OH on October 09, 2006 at 11:49:06 from (198.57.19.126):
In Reply to: Working small plots posted by JackT on October 09, 2006 at 09:21:03:
I use the "divide and conqure" methed. On wide areas that would have me dead heading from side to side I start in the middle and work out. Once I get to the point where I am not basicly making a U turn, I do it again. Plowing can be tough this way but do-able, just plan head and don't start with a dead furrow in the middle. If the field isn't square I work the bigest square I can make and go back for the odd piece(s). If dealing with an angled piece, I either seperate it out or run the longest part (angle)and deal with a smaler corner.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|