|
Tractor Talk Discussion Board |
Re: OT Radio antenna (John T)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on October 08, 2006 at 09:39:08 from (66.244.90.5):
In Reply to: OT Radio antenna (John T) posted by BUDD on October 08, 2006 at 07:02:24:
Budd, I gotta rake hay so Im not puttin much time or thought into this sooooooooooo I think its what I experienced before n several other gents below thought. I had one of those antenna tuner switch boxes once but regardless how I trimmed it there was nooooo difference. The problem was without using and properly bonding n grounding the shield any all unshielded hook up wiring into or out of the box was acting as a stray antenna so allllllll frequencies were getting to the receiver n the tuner had no affect. I bet yours is the same situation i.e. all that wire acts as its own antenna and it will unless the shield is bonded at both ends and the actual switch is inside a faraday shield i.e. a bonded metallic enclosure. If an antenna is grounded out right where it connects to a receiver any signal strength should be shunted but if theres much unprotected unenclosed unshielded wire or anything lying around loose YOU HAVE AN ANTENNA PS my best area is DC tractor electricity n charging n ignition and secondary AC power distribution but if you get into electronics or radio or RF Im pretty much "out to lunch" so take this for what you paid NOTHING lol My old buddy Gerald is a practicing engineer (Im long retired) so better listen to him n others also John T
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|