Tractor Talk Discussion Board |
Re: Tractor Wheel Weights
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Sherburne NY on October 05, 2006 at 18:59:53 from (74.32.162.133):
In Reply to: Tractor Wheel Weights posted by Reverend Brian Jenkins on October 05, 2006 at 16:59:50:
What ever you are hitching to on the tractor is to high. If you have an 11 hole drawbar on the liftarms make sure the lift arms are down when pulling. If you have a drawbar bolted to the bottom of the rear axle, turn it over so the hitch point is lowest. Does your tractor hitch look like the one in this picture?? I hope you are not hitching to where the top link is supposed to hook, above the axle, you'll get killed
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|