|
Tractor Talk Discussion Board |
Re: Quite a sight
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by noncompos on October 02, 2006 at 23:08:33 from (71.34.66.23):
In Reply to: Re: Quite a sight posted by idontno on October 02, 2006 at 21:11:48:
Well, if you figure 640 acres to a Section, 50K acres is 78.125 sq mi per my hand Sharp, assuming, of course, that a Section is a sq mi...but sections don't always have 640 acres, or shouldn't, because of the curvature of the Earth, but they often showed some as a full 640 and shorted some down the line to compensate, which is why some of the Gov't surveys come out with those skinny little Sections, or part Sections numbered in Gov't Lots...unless, of course, there's pieces taken out for navigable waterways and such, leaving the quarter quarters remaining in Gov't Lots...oh, he--, just figure 78 sq mi, more or less...
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|