Tractor Talk Discussion Board |
Another good day
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on October 01, 2006 at 20:09:08 from (205.188.117.14):
I got home form visiting my girlfriend for the weekend around 1:30, then started to get ready to chop some corn. I adjusted the shear bar and went at it, first going for the 4 rows left in all the feilds for the crop adjuster that went through on Firday. Got those off, and with the shear bar adjusted nice & close, it cut the husks just fine. I try to do it every 10 loads or so. It really does make a heck of a difference. I then went after the other feilds that got planted later and they were MUCH nicer than what we got from the early planting. Actually reached to the top of the canopy on our 1855, about 1 1/2' or so on average taller than the earlier feilds. Pretty glad we borrowed the neighbors 2 wagons to go with our own 2, then I didn't have to wait for an empty wagon like I would have had to to otherwise. Now I've got all 4 loaded and waiting to be unloaded tomorrow, I just may be able to fill then again between school and work. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|