Re: Nice Morning

Posted by Allan In NE on October 01, 2006 at 10:49:14 from (148.78.243.26):

In Reply to: Re: Nice Morning posted by JJ. in B.C. on October 01, 2006 at 10:33:37:

Dunno if you can see much from this picture or not.

Basically, just a 3-point square toolbar with gauge wheels. Into each end of the toolbar is a telescoping smaller bar with pin holes every six inches or so for width adjustment of the two rakes.

Then, at the far outer end of the smaller bar(s) is welded a "mini-drawbar" to hook the rake to.

Really works slick on the corners. The outside rake sweeps out wide and the inside rake, due to the direction of sideways pull, swings over towards that outer rake and closes in on it.

Keeps the windrow perfect at all times, even going around a corner.

Allan

Replies:

• Re: Nice Morning Allan In NE 10:59:09 10/01/06 (1)
  • Re: Nice Morning JJ. in B.C. 19:07:02 10/01/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]