Machine Work Help

Posted by kopeck on September 29, 2006 at 14:58:06 from (216.227.9.188):

I'm trying to estimate what it's going to cost to rebuild my little Kubota D-600.

I've got the parts priced out but I didn't have enough time to contact the local machine shop before they closed for the weekend. There are four main bearing surfaces, and three rod bearing surfaces and they would probably be machined down .2 mm.

The only variable here is that the rod bearing surfaces might still be with in spec (I spun a main bearing) so there's a possibility that I would only have to have the four mains turned.

I know that prices can vary, but I'll I'm looking for is a ball park figure and thought maybe someone had been to the machine shop recently.

Thanks!

K

Replies:

• Re: Machine Work Help banjo 21:51:39 09/29/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]