|
Tractor Talk Discussion Board |
Re: John T,,
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gerald J. on September 22, 2006 at 07:28:00 from (67.0.102.134):
In Reply to: John T,, posted by ChadS on September 22, 2006 at 06:50:36:
If the breaker on the pole trips at 45 amps, its damaged. Whether a marginally larger breaker can be put in the box depends on the maker and part number for the box. Some makes can, some can't. Often the lowest bid box is compact and doesn't have room for bending larger conductors into place. And that problem is made worse by using aluminum wire since copper is probably not affordable these days. Electrically, running a separate line from the pole (with its own breaker) for the furnace would work but I don't think its NEC approved because it would be safer for the house to have only one disconnect. And at the pole the power company needs to have 200 amp meter loop and enough transformer to support that load. Having larger wires will get more of the energy you pay for to the house instead of warming outdoors with power lost in the wires and for thermostatically controlled loads like furnace, oven, and water heater may reduce the energy costs a couple percent. But not enough that you can prove it in the noise of variations in use brought about by weather. The minimum wire size needed depends on the length of the service run, but there's nothing wrong with going a size larger if it will fit the conduit and the lugs on the breakers and you can afford it. Gerald J, electrical engineer
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|