Re: massey ferguson front end pivot

Posted by Irv Slagter on September 18, 2006 at 10:40:02 from (12.104.192.35):

In Reply to: massey ferguson front end pivot posted by david holderness on September 17, 2006 at 21:29:26:

I just got done doing that to my TO-20. Mine was oval shaped a quarter of an inch. I welded the hole back at the top side of the cradle to a little smaller than round and very carfully ground it back to round with a small air die grinder using a 1/2 carbide burr. If it doesn't come out exactly like you want it, you can always weld it in again and work it down again. I used a lot of trial fitting to get the end result. It took me about an hour. Besides, what have you got to lose? I also made a new pin bacause the original was a little too short. But, instead of putting a crank hole in it, I left it solid and drilled it for a grease hole to the bushing.
Irv

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]