|
Tractor Talk Discussion Board |
Re: Rim modification
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Chris Cash on September 11, 2006 at 11:53:38 from (137.244.215.51):
In Reply to: Re: Rim modification posted by RAB on September 11, 2006 at 11:30:13:
I had thought about taking a 3/16 plate and welding it to the outside of the rim. Then fill in the old lug holes with weld like really big spot welds. Then grind them down smooth and drill the new ones. I figure if I did like a doughnut plate and made the hub hole larger than that on the rim I could run one bead on the inside if the plate and one on the outside coupled with the lug hole welds. I'm not going to fill the tires with water. I just want a set of turf wheels so I can mow grass. All of my property is flat so traction isn't a factor. Do you think this idea would be O.K.?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
