|
Tractor Talk Discussion Board |
Re: Flail Mower?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MarkB_MI on September 03, 2006 at 07:14:58 from (64.31.11.43):
In Reply to: Flail Mower? posted by Chances R on September 03, 2006 at 06:49:03:
A "Flail mower" is a mower that uses a horizontal shaft with knifes attached to it, rather than vertical shaft like most mowers. (Not to be confused with a reel mower, which looks like an old-fashioned hand push mower.) There are a variety of flail mowers used for everything from finish mowing of lawns up to heavy brush. They are popular with state highway maintenance departments because they don't tend to throw debris out towards the road. The main advantages of the flail mower are improved safety and finish over a conventional rotary mower. The flail knives pick up grass that the tractor tires have flattened, making for a better finish than a typical finish mower. The main disadvantages of the flail mower are that they cost more to purchase and require more horsepower to operate than a conventional mower. The most widely known manufacturer of flail mowers is Alamo, formerly Mott (link below). Several other implement manufacturers have produced flail mowers. I've been told that the Ford and John Deere flails were made by Bushhog, but I don't know that for fact. If you're considering the purchase of a flail mower, check it out very carefully. I know from experience that many of the parts for older Mott mowers are outrageously expensive to replace. There are a couple of companies (Montage and Flailmaster) who make replacement parts for older flail mowers; these are quite a bit cheaper than the OEM parts.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|