Tractor Talk Discussion Board |
Re: Europe versus America
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JWCinMS on August 31, 2006 at 10:07:28 from (199.133.80.226):
In Reply to: Europe versus America posted by Bill Brox on August 31, 2006 at 08:01:50:
Many have mentioned the narrow fronts (one or two wheels) allowed for sharper turning at the end of rows, additionally most early rowcrop cultivators were front mounted and were easier to mount on a narrow front. With a narrow front you could drive into the cultivator then fasten it to its mounting points and go on your way. With a wide front you would have to drag the cultivators in from the side then attach them and vice versa when removing. When a tractor did multiple task during the season such as plowing, mowing and cultivating the wheel spacing might have to be adjusted back and forth several times during the season. The narrow fronts only required the rear axle to be changed. Single wheels were prevalent with mounted cotton pickers more so with the highdrum models with drop axles for higher clearance. Cotton was often picked more than once if the harvest season was long enough. You did not want to break down the stalks or knock off unopened bowls during the first picking.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|