JD 2010 Hydraulic problem.

Posted by Harold Kellogg on August 23, 2006 at 11:13:29 from (69.54.220.30):

I have a John Deere 2010 and need to tap in to the hydraulic system to raise and lower a front end loader. The tractor has power steering and only one remote hydraulic control.I am currently coupling into the rear outlet but I have to uncouple the loader to use the remote cylinder for other uses. I can't use the loader and a log splitter,for instance, at the same time. This system is an 'open center' type which needs to have the fluid circulate at all times. Where can I tap into the system to run the loader? There is a plug in the mounting casting that supplies pressure to the remote control valve. Can I use this port? Also, I need a good hydraulic pump as the old one has gone bad. Thank you.
Harold Kellogg 989-584-3286

Replies:

• Re: JD 2010 Hydraulic problem. haybaker 06:50:48 10/01/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]